Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Power Window Master Switch Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit supplies power to operate the power window master switch.

WIRING DIAGRAM


B111214E02


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (POWER WINDOW MASTER SWITCH - BATTERY AND BODY GROUND)


    B063771E01
  1. Disconnect the K5 (L5) connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    LHD Models:
    Tester Connection
    Condition
    Specified Condition
    L5-6 (B) - Body ground
    Always
    10 to 14 V
    L5-7 (BW) - Body ground
    Ignition switch ON
    10 to 14 V
    RHD Models:
    Tester Connection
    Condition
    Specified Condition
    K5-6 (B) - Body ground
    Always
    10 to 14 V
    K5-7 (BW) - Body ground
    Ignition switch ON
    10 to 14 V


    Standard resistance:
    LHD Models:
    Tester Connection
    Condition
    Specified Condition
    L5-1 (E) - Body ground
    Always
    Below 1 Ω
    RHD Models:
    Tester Connection
    Condition
    Specified Condition
    K5-1 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION IN PROBLEM SYMPTOMS TABLE