Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM


E110876E01


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER


    E110872E03
  1. Disconnect the radio receiver I2 connector.

  1. Measure the resistance according to the value in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    GND - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the values in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    B - GND
    Always
    10 to 14V
    ACC - GND
    Ignition SW ACC
    10 to 14V



OK
RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR