Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Speaker Circuit

for Preparation Click here


DESCRIPTION

The sound signal that has been amplified by the radio receiver (built-in amplifier) is sent to the speakers from the radio receiver through this circuit.

WIRING DIAGRAM


E110873E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR


    E111871E01
  1. Disconnect the connectors shown in the illustration from the radio receiver, and speakers.

  1. Measure the resistance between the speaker and the radio receiver to check for an open circuit in the wire harness.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between the speaker and body ground to check for a short circuit in the wire harness.

    Standard resistance:
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT FRONT NO.1 SPEAKER
  1. Resistance check.

    1. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Approximately 4 Ω



NG
REPLACE FRONT NO.1 SPEAKER
OK


3.INSPECT REAR SPEAKER
  1. Resistance check.

    1. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Approximately 4 Ω



NG
REPLACE REAR SPEAKER
OK


4.CONFIRM MODEL

Result:

Result
Proceed to
6 Speaker
A
4 Speaker
B



B
RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL
A


5.INSPECT ROOF SPEAKER
  1. Resistance check.

    1. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Approximately 6 Ω



NG
REPLACE ROOF SPEAKER
OK

RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL