Home › ENGINE · 2TR-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT E.F.I. ENGINE COOLANT TEMPERATURE SENSOR


  1. Check the resistance.


    A108624E04


    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester connection
      Specified Condition
      1 (E2) - 2 (THW)
      2.32 to 2.59 kΩ at 20 °C (68 °F)
      1 (E2) - 2 (THW)
      0.310 to 0.326 kΩ at 80 °C (176 °F)

      NOTICE:
      If checking the engine coolant temperature sensor in water, be careful not to allow water to intrude into the terminals. After checking, clean off water on the engine coolant temperature sensor.

      If the result is not as specified, replace the engine coolant temperature sensor.