Home › BODY › MIRROR › OUTER MIRROR SWITCH

OUTER MIRROR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT OUTER MIRROR SWITCH ASSEMBLY


B102670E03
  1. Inspect the mirror switch operation.

    1. Select "L" on the left/right adjustment switch.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      4 - 8
      6 - 7
      UP
      Below 1 Ω
      4 - 7
      6 - 8
      DOWN
      5 - 8
      6 - 7
      LEFT
      5 - 7
      6 - 8
      RIGHT

    3. Select "R" on the left/right adjustment switch.

    4. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      3 - 8
      6 - 7
      UP
      Below 1 Ω
      3 - 7
      6 - 8
      DOWN
      2 - 8
      6 - 7
      LEFT
      2 - 7
      6 - 8
      RIGHT

  1. Inspect the retract switch operation.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      7 - 9
      8 - 10
      OFF
      Below 1 Ω
      7 - 10
      8 - 9
      ON
      10 kΩ or higher