COOLING SYSTEM > INSPECTION |
| 1. INSPECT WATER PUMP ASSEMBLY |
![]() |
Check that there are no engine coolant leaks from the drain hole.
Check that the pulley can be turned smoothly and that there is no abnormal noise from the bearing.
| 2. INSPECT THERMOSTAT |
![]() |
The valve opening temperature is provided on the thermostat.
![]() |
Immerse the thermostat in water and gradually heat the water.
![]() |
Check the valve opening temperature.
Check the valve lift.
Check that the valve is fully closed when the thermostat is at low temperatures (below 40°C (104°F)).
| 3. INSPECT RADIATOR CAP SUB-ASSEMBLY |
![]() |
Using a radiator cap tester, slowly pump the tester and check that air is coming from the vacuum valve.
Pump the tester and measure the relief valve opening pressure.