COOLING SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT COOLING SYSTEM |
Fill the radiator with coolant and attach a radiator cap tester to the radiator.
Warm up the engine.
Using a radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17.1 psi), and check that the pressure does not drop.
| 2. INSPECT ENGINE COOLANT LEVEL |
Check that the engine coolant level is between the LOW and FULL lines when the engine is cold. If the engine coolant is low, check for leaks and add "TOYOTA Super Long Life Coolant (SLLC)" or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology to the FULL line.
| 3. INSPECT ENGINE COOLANT QUALITY |
Remove the radiator cap.
Check if there is any excessive deposits of rust or scale around the radiator cap and radiator filler hole. The coolant should be free from oil.
Install the radiator cap.
| 4. INSPECT FINS FOR BLOCKAGE |
![]() |
Check that the radiator and condenser are not blocked with leaves, dirt, or insects. Clean the hose connection. If the fins are clogged, wash them with water or a steam cleaner and dry with compressed air.
| Injection Pressures kPa (kg/cm2, psi) | Injection Distance mm (in.) |
| 2,942 to 4,903 (30 to 50, 427 to 711) | 300 (11.811) |
| 4,903 to 7,845 (50 to 80, 711 to 1,138) | 500 (19.685) |