OIL FILTER > INSTALLATION |
| 1. INSTALL OIL FILTER SUB-ASSEMBLY |
Check and clean the oil filter installation surface.
Apply clean engine oil to the rubber gasket of a new oil filter.
Instal the oil filter, and tighten it by hand until the rubber gasket contacts the installation surface.
![]() |
Using SST, tighten it by an additional 3/4 turn to seat the filter.
| 2. ADD ENGINE OIL |
Fill with fresh engine oil.
| Oil capacity | |
Drain and refill
| 6.9 litters (7.3 US qts, 6.1 lmp. qts) 6.1 litters (6.4 US qts, 5.4 lmp. qts) |
| Dry fill | 7.6 litters (8.0 US qts, 6.7 lmp. qts) |
Reinstall the oil filler cap.
| 3. INSPECT CHECK FOR ENGINE OIL LEAKS |