Home › ENGINE ยท 5L-E › STARTING › STARTER (for 2.2kW Type)

STARTER (for 2.2kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY
  1. Remove the screw and terminal 50 wire.



    B000461E01
  1. Remove the nut and disconnect the terminal C wire.

  1. Remove the 2 crews and O-rings, and pull out the starter yoke assembly with the armature assembly.



2. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    B000465E01
  1. Remove the 2 screws and magnet starter switch assembly.

  1. Remove the return spring.



    B000464E01
  1. Remove the following parts from the starter housing.
    (1)
    Starter clutch sub-assembly
    (2)
    Starter armature pinion
    (3)
    Starter idler pinion
    (4)
    Retainer
    (5)
    Clutch roller



    P005056E01
  1. Using a magnetic finger, remove the steel ball.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    N000562E01
  1. Using a screwdriver, hold the spring back and disconnect the brush.

  1. Disconnect the 4 brushes and remove the brush holder assembly.



4. REMOVE STARTER ARMATURE ASSEMBLY


    P005488E01
  1. Using a plastic hammer, tap the end of the starter yoke assembly and remove the armature assembly.