GENERATOR > DISASSEMBLY |
| 1. REMOVE REAR END COVER |
![]() |
Remove the nut and terminal insulator.
Remove the bolt, 3 nuts, plate terminal, and rear end cover.
| 2. REMOVE BRUSH HOLDER AND REGULATOR |
Remove the brush holder cover.
![]() |
Remove the 2 screws and brush holder.
Remove the seal plate.
Remove the 3 screws and regulator.
| 3. REMOVE GENERATOR HOLDER W/ RECTIFIER |
![]() |
Remove the 4 screws and generator holder w/ rectifier.
Remove the 4 rubber insulators.
| 4. REMOVE RECTIFIER END FRAME |
![]() |
Remove the 4 nuts and cord clamp.
![]() |
Using SST, remove the rectifier end frame.
Remove the washer from the rotor.
| 5. REMOVE GENERATOR ROTOR ASSEMBLY |
![]() |
Using SST and press, press out the rotor.