GENERATOR > REASSEMBLY |
| 1. INSTALL GENERATOR ROTOR ASSEMBLY |
Using a press, press in the rotor.
Place the washer to the rotor.
| 2. INSTALL RECTIFIER END FRAME |
![]() |
Using a 17 mm socket wrench and press, slowly press in the rectifier end frame.
![]() |
Install the cord clamp and 4 nuts.
| 3. INSTALL GENERATOR HOLDER W/ RECTIFIER |
![]() |
Install the 4 rubber insulators on the lead wires.
![]() |
While pushing down on the rectifier holder, install it with the 4 screws.
| 4. INSTALL BRUSH HOLDER AND REGULATOR |
![]() |
Install the regulator with the 3 screws.
Place the seal plate.
Install the brush holder with the 2 screws.
Place the brush holder cover.
| 5. INSTALL REAR END COVER |
![]() |
Install the rear end cover and plate terminal with the bolt and 3 nuts.
Install the terminal insulator with the nut.