Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › SUN GEAR AND ONE-WAY CLUTCH

SUN GEAR AND ONE-WAY CLUTCH > REASSEMBLY

for Preparation Click here



1. INSTALL SUN GEAR INPUT DRUM SHAFT SNAP RING


    AT08182
  1. Using a screwdriver, install the snap ring on the planetary sun gear.



2. INSTALL SUN GEAR INPUT DRUM


    AT08181
  1. Place a wooden block or similar object as a work stand and place the planetary sun gear onto it.

  1. Install the sun gear input drum onto the planetary sun gear.



    AT07897
  1. Using a snap ring expander, install the snap ring.



3. INSTALL SUN GEAR SHAFT OIL SEAL RING


    AT08189
  1. Coat the 2 oil seal rings with ATF.

  1. Install the 2 oil seal rings onto the planetary sun gear.

    NOTICE:
    Do not over-spread the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.



4. INSTALL ONE WAY CLUTCH THRUST WASHER NO.1

HINT:
Make sure that the lug shapes fit into the holes in the sun gear input drum.



5. INSTALL ONE WAY CLUTCH ASSEMBLY


    AT01643E02
  1. Install the 1 way clutch assembly.



6. INSPECT ONE WAY CLUTCH ASSEMBLY


    AT08440E02
  1. Hold the planetary sun gear, and turn the 1 way clutch assembly Check that the 1 way clutch assembly hub can be freely clockwise and locked counterclockwise.