STARTING SYSTEM (for 2.2kW Type) > INSPECTION |
| 1. INSPECT STARTER ASSEMBLY |
![]() |
Perform pull-in test.
Disconnect the field coil lead wire from terminal C.
Connect the battery to the magnetic switch as shown. Check that the clutch pinion gear moves outward.
![]() |
Perform holding test.
When the battery is connected as above with the clutch pinion gear out, disconnect the negative (-) lead from terminal C. Check that the pinion gear remains out.
![]() |
Inspect clutch pinion gear return.
Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns inward.
![]() |
Perform the operation test without load.
Connect the field coil lead wire to terminal C.
Grip the starter with a vise.
Connect the battery and ammeter to the starter as shown.
Check that the ammeter reads the specified current.
| 2. INSPECT STARTER RELAY ASSEMBLY |
![]() |
Continuity inspection.
Using an ohmmeter, measure the resistance between each terminal.
| Between terminals | Specified condition |
| 1-2 | Below 1 Ω |
| 3-5 | 10 kΩ or higher |
Using an ohmmeter, measure the resistance between terminals 3 and 5 when the between voltage is applied across terminals 1 and 2.