Home › TRANSMISSION · A340E AUTOMATIC TRANSMISSION › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT SHIFT SOLENOID VALVE S1


    G038832E01
  1. Remove the shift solenoid valve S1.

  1. Measure the resistance according to the value(s) in the table below.
    Resistance: 
    Tester Connection
    Specified Condition 20°C (68°F)
    Solenoid Connector (S1) - Solenoid Body (S1)
    11 to 15 Ω

  1. Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.

    OK:

    The solenoid makes an operating sound.



2. INSPECT SHIFT SOLENOID VALVE S2


    G038832E02
  1. Remove the shift solenoid valve S2.

  1. Measure the resistance according to the value(s) in the table below.
    Resistance: 
    Tester Connection
    Specified Condition 20°C (68°F)
    Solenoid Connector (S2) - Solenoid Body (S2)
    11 to 15 Ω

  1. Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.

    OK:

    The solenoid makes an operating sound.



3. INSPECT SHIFT SOLENOID VALVE SLT


    G020767E27
  1. Remove the shift solenoid valve (SLT).

  1. Measure the resistance according to the value(s) in the table below.
    Resistance: 
    Tester Connection
    Specified Condition 20°C (68°F)
    1 - 2
    5.0 to 5.6 Ω

  1. Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.

    OK:

    The solenoid makes an operating sound.