MANUAL TRANSMISSION UNIT > INSPECTION |
| 1. INSPECT COUNTER SHAFT 5TH GEAR THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the counter shaft 5th gear thrust clearance.
| 2. INSPECT COUNTER SHAFT 5TH GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance of the counter shaft 5th gear.
| 3. INSPECT SYNCHRONIZER RING OUTER NO.3 |
![]() |
Apply gear oil to the cone part of the gear spline piece No.5, and check that it does not turn in either direction while pushing the synchronizer ring outer No.3 against the gear spline piece No.5.
If it turns, replace the synchronizer ring.
![]() |
Measure the clearance between the synchronizer ring outer No.3 and gear spline piece No.5 while pushing the synchronizer ring outer No.3 against the cone part of the gear spline piece No.5.
| 4. INSPECT TRANSMISSION HUB SLEEVE NO.3 |
![]() |
Check that the counter shaft 5th gear and transmission hub sleeve No.3 slide smoothly each other.
Check the tip of the spline gear of the transmission hub sleeve No.3 for wear.
If there are any defects, replace the transmission hub sleeve No.3.
![]() |
Using vernier calipers, measure the width of the transmission hub sleeve No.3 groove and the thickness of the claw part of the shift fork No.3, and calculate the clearance.
| 5. INSPECT COUNTER SHAFT 5TH GEAR |
![]() |
Using a cylinder gauge, measure the inner diameter of the counter 5th gear.
| 6. INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY |
![]() |
Using a caliper gauge, measure the inner diameter of the reverse idler gear.
Using a micrometer, measure the outer diameter of the sliding part of the reverse idler gear on the reverse idler gear shaft.
Subtract the reverse idler gear shaft inside diameter from the reverse idler gear diameter clearance.
![]() |
Using a feeler gauge, measure the thrust clearance of the shoe part between the reverse idler gear and the reverse shift arm.