Home › TRANSMISSION ยท G55 MANUAL TRANSMISSION › INPUT SHAFT

INPUT SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL INPUT SHAFT FRONT BEARING


    C086534
  1. Using SST and a press, press in a new input shaft front bearing.

    SST
    09316-60011   (09316-00031)



    D033850
  1. Select a snap ring that will allow minimum amount of axial play.

    Standard clearance:
    0.1 mm (0.0039 in.) or less

    Front bearing shaft snap ring thickness 
    Mark
    Thickness: mm (in.)
    0
    2.05 to 2.10 (0.0807 to 0.0827)
    1
    2.10 to 2.15 (0.0827 to 0.0847)
    2
    2.15 to 2.20 (0.0847 to 0.0866)
    3
    2.20 to 2.25 (0.0866 to 0.0886)
    4
    2.25 to 2.30 (0.0886 to 0.0906)
    5
    2.30 to 2.35 (0.0906 to 0.0925)



    D033851
  1. Using a snap ring expander, install the snap ring.



2. INSTALL INPUT SHAFT BEARING


    C086536
  1. Coat the 13 input shaft bearings with MP grease, install them to the input shaft.



3. INSTALL SYNCHRONIZER RING NO.2


    C067214
  1. Coat the synchronizer ring No.2 with gear oil, and install it to the input shaft.