COUNTER GEAR AND REVERSE IDLER GEAR > INSPECTION |
| 1. INSPECT COUNTER SHAFT 5TH GEAR RADIAL CLEARANCE |
![]() |
Install the 5th gear thrust washer lock ball, the 5th gear thrust washer, and the 5th gear to the counter gear.
Using a dial indicator, measure the counter shaft 5th gear radial clearance.
| 2. INSPECT SYNCHRONIZER RING NO.3 |
![]() |
Apply gear oil to the gear spline piece No.5 cone. Press the synchronizer ring against the gear spline piece No.5 cone and check that the synchronizer ring does not turn in the directions shown in the illustration.
If it turns, replace the synchronizer ring.
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring No.3 back and gear spline piece No.5 spline end.
| 3. INSPECT TRANSMISSION HUB SLEEVE NO.3 |
![]() |
Check the sliding condition between the transmission hub sleeve No.3 and counter shaft 5th gear.
Check that the spline gear's edges of the transmission hub sleeve No.3 are not worn down.
![]() |
Using vernier calipers, measure the width of the transmission hub sleeve No.3 groove and the thickness of the claw part on the gear shift fork No.3, and calculate the clearance.
| 4. INSPECT COUNTER SHAFT 5TH GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 5th gear.
| 5. INSPECT COUNTER GEAR |
![]() |
Using a micrometer, measure the outside diameter of the journal surface.
| 6. INSPECT COUNTER GEAR FRONT BEARING OR ROLLER |
![]() |
Make sure the front bearing rotates smoothly.
If the bearing does not rotate smoothly, replace the bearing.