COUNTER GEAR AND REVERSE IDLER GEAR > DISASSEMBLY |
| 1. INSPECT COUNTER SHAFT 5TH GEAR RADIAL CLEARANCE |
![]() |
Install the 5th gear thrust washer lock ball, the 5th gear thrust washer, and the 5th gear to the counter gear.
Using a dial indicator, measure the counter shaft 5th gear radial clearance.
| 2. REMOVE COUNTER 5TH GEAR BEARING |
![]() |
Remove the 5th gear bearing from the 5th gear.
| 3. REMOVE TRANSMISSION HUB SLEEVE NO.3 |
![]() |
Using a snap ring expander, remove the snap ring from the 5th gear.
![]() |
Remove the hub sleeve No.3, 2 synchromesh shifting keys No.3, key spring (return spring), and key spring (C spring) from the 5th gear.
| 4. INSPECT SYNCHRONIZER RING NO.3 |
![]() |
Apply gear oil to the gear spline piece No.5 cone. Press the synchronizer ring against the gear spline piece No.5 cone and check that the synchronizer ring does not turn in the directions shown in the illustration.
If it turns, replace the synchronizer ring.
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring No.3 back and gear spline piece No.5 spline end.
| 5. INSPECT TRANSMISSION HUB SLEEVE NO.3 |
![]() |
Check the sliding condition between the transmission hub sleeve No.3 and counter shaft 5th gear.
Check that the spline gear's edges of the transmission hub sleeve No.3 are not worn down.
![]() |
Using vernier calipers, measure the width of the transmission hub sleeve No.3 groove and the thickness of the claw part on the gear shift fork No.3, and calculate the clearance.
| 6. INSPECT COUNTER SHAFT 5TH GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 5th gear.
| 7. INSPECT COUNTER GEAR |
![]() |
Using a micrometer, measure the outside diameter of the journal surface.
| 8. INSPECT COUNTER GEAR FRONT BEARING OR ROLLER |
![]() |
Make sure the front bearing rotates smoothly.
If the bearing does not rotate smoothly, replace the bearing.
| 9. REMOVE COUNTER GEAR FRONT BEARING OR ROLLER |
![]() |
Using a snap ring expander, remove the counter gear front bearing snap ring No.2 from the counter gear.
![]() |
Using SST, a press, and a socket wrench 14 mm, remove the counter gear front bearing from the counter gear.