SHIFT LEVER SHAFT HOUSING > DISASSEMBLY |
| 1. REMOVE LEVER LOCK PIN NO.2 |
![]() |
Remove the nut from the lever lock pin No.2.
![]() |
Using a brass bar and a hammer, remove the shift lever lock pin No.2.
| 2. REMOVE SELECT OUTER LEVER |
![]() |
Remove the select outer lever and washer from the select lever shaft sub-assembly.
| 3. REMOVE SELECT LEVER SHAFT SUB-ASSEMBLY |
![]() |
Remove the select lever shaft sub-assembly from the shift lever shaft housing.
| 4. REMOVE SHIFT OUTER LEVER LOCK PIN |
![]() |
Remove the nut from the shift outer lever lock pin.
![]() |
Using a brass bar and a hammer, remove the shift outer lever lock pin.
| 5. REMOVE SHIFT OUTER LEVER NO.1 |
![]() |
Remove the shift outer lever No.1 from the shift and select lever shaft.
| 6. REMOVE SHIFT LEVER BOOT |
![]() |
Remove the shift lever boot from the shift lever shaft housing.
| 7. REMOVE SHIFT AND SELECT LEVER SHAFT |
![]() |
Using a pin punch (5 mm) and a hammer, remove the shift lever shaft set slotted spring pin.
![]() |
Pull out the shift and select lever shaft and remove the shift and select lever.
| 8. REMOVE SELECT SPRING SEAT NO.1 |
![]() |
Remove the select spring seat No.1 and spring from the shift lever shaft housing.
| 9. REMOVE REVERSE RESTRICT PIN NO.1 |
![]() |
Using a hammer, drive a screw extractor into the reverse restrict pin slotted spring pin.
Pull out the reverse restrict pin slotted spring pin from the shift lever shaft housing.
![]() |
Remove the reverse restrict pin No.1 and spring from the shift lever shaft housing.
| 10. REMOVE SHIFT LEVER NO.2 SHAFT OIL SEAL |
![]() |
Using a screwdriver with its tip taped, remove the shift lever No.2 shaft oil seal from the shift lever shaft housing.
| 11. REMOVE SHIFT LEVER SHAFT OIL SEAL |
![]() |
Using a screwdriver with its tip taped, remove the shift lever shaft oil seal from the shift lever shaft housing.