Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › INTAKE AIR TEMPERATURE SENSOR

INTAKE AIR TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL DIESEL TURBO INLET AIR TEMPERATURE SENSOR


    A113531E01
  1. Install a new gasket and the diesel turbo inlet air temperature sensor.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the diesel turbo inlet air temperature sensor connector.



2. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transaxle)


    C101768E01
  1. Coat a new O-ring with ATF and install the oil filler tube.

  1. Install the oil filler tube with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 8 ft.*lbf }



3. INSTALL TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY (for Automatic Transaxle)


4. INSTALL ENGINE SERVICE HOLE COVER NO.2
  1. Install the engine service hole cover No.2 with the 3 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    A113039
  1. Return the carpet.



5. INSTALL INTAKE AIR TEMPERATURE SENSOR


    A106858
  1. Install the intake air temperature sensor.

  1. Connect the intake air temperature sensor connector.



6. INSTALL AIR CLEANER INLET SUB-ASSEMBLY


    A106857
  1. Temporarily install the air cleaner inlet sub-assembly with the 2 bolts.

  1. Install the clip, and tighten the 2 bolts.

    Torque:
    18 N*m{ 180 kgf*cm , 13 ft.*lbf }



7. INSTALL FRONT BUMPER


8. INSTALL STEP PLATE COVER RH


9. INSTALL STEP PLATE COVER LH


10. INSTALL RADIATOR GRILLE