Home › ENGINE · 2KD-FTV › ENGINE CONTROL SYSTEM › INTAKE AIR TEMPERATURE SENSOR

INTAKE AIR TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT INTAKE AIR TEMPERATURE SENSOR


    A098859E05
  1. Using an ohmmeter, measure the resistance between the terminals.

    Standard resistance:
    2.21 to 2.65 kΩ at 20°C (68°F)

    NOTICE:
    When checking the intake air temperature sensor in the water, keep the terminals dry. After the check, wipe the sensor dry.

    If the result is not as specified, replace the sensor.



2. INSPECT DIESEL TURBO INLET AIR TEMPERATURE SENSOR


    Z017274E05
  1. Using an ohmmeter, measure the resistance between the terminals.

    Standard resistance:
    2.21 to 2.65 kΩ at 20°C (68°F)

    NOTICE:
    When checking the intake air temperature sensor in the water, keep the terminals dry. After the check, wipe the sensor dry.

    If the result is not as specified, replace the sensor.