Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › INTAKE AIR TEMPERATURE SENSOR

INTAKE AIR TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR GRILLE


    B101611E01
  1. Remove the 2 clips and 2 screws.

  1. Release the 6 claws and 4 clips and remove the radiator grille.



2. REMOVE STEP PLATE COVER LH


3. REMOVE STEP PLATE COVER RH


4. REMOVE FRONT BUMPER


    E109046E01
  1. Remove the 8 clips and 3 bolts.

  1. Release the 12 claws and remove the bumper.

  1. Disconnect the connectors. (w/ fog light)



5. REMOVE AIR CLEANER INLET SUB-ASSEMBLY


    A106857
  1. Remove the 2 bolts, clip, and the air cleaner inlet sub-assembly.



6. REMOVE INTAKE AIR TEMPERATURE SENSOR


    A106858
  1. Disconnect the intake air temperature sensor connector.

  1. Remove the intake air temperature sensor.



7. REMOVE ENGINE SERVICE HOLE COVER NO.2


    A113043
  1. Roll up the carpet.

  1. Remove the 3 bolts and the engine service hole cover No.2.



8. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY (for Automatic Transaxle)


    C101767
  1. Remove the transmission oil level gauge sub-assembly from the transmission oil filler tube.



9. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transaxle)


    C101768E01
  1. Remove the 2 bolts transmission oil filler tube sub-assembly.

  1. Remove the O-ring from the oil filler tube sub-assembly.



10. REMOVE DIESEL TURBO INLET AIR TEMPERATURE SENSOR


    A113531E01
  1. Disconnect the diesel turbo inlet air temperature sensor connector.

  1. Remove the diesel turbo inlet air temperature sensor and gasket.