Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR BLOWER SWITCH (for Heater)

REAR BLOWER SWITCH (for Heater) > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B115746
  1. Remove the 5 clips and front door scuff plate LH.



2. REMOVE FRONT DOOR OPENING TRIM LH


3. REMOVE SEAT BELT ANCHOR COVER


    B103255E01
  1. Remove the 2 clips.

  1. Disengage the claw and then remove the seat belt anchor cover.



4. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH


    B103254
  1. Remove the bolt and disconnect front seat outer belt assembly RH.



    B101641E01
  1. Using a screwdriver, disengage the 2 claws and cover.

    HINT:
    Tape the screwdriver tip before use.



    B101642
  1. Remove the bolt and disconnect front seat outer belt assembly RH.



5. REMOVE CENTER PILLAR GARNISH COVER LOWER LH


    B106182E01
  1. Using a screwdriver, disengage the 4 clips and remove the center pillar garnish lower LH.



6. REMOVE SEAT ASSEMBLY LH
  1. Disconnect connector.



    B106197
  1. Remove the nut and 3 bolts.

  1. Remove the seat assembly LH.



7. REMOVE CENTER PILLAR GARNISH LOWER LH (Semi Trim Type)


    B106182E01
  1. Using a screwdriver, disengage the 4 clips and remove the center pillar garnish lower LH.



8. REMOVE BACK DOOR SCUFF PLATE (Full Trim Type)


    B106176E01
  1. Using a screwdriver, disengage the 7 clips and 4 claws and remove the back door scuff plate.

    HINT:
    Tape the screwdriver tip before use.



9. REMOVE BACK DOOR WEATHERSTRIP (Full Trim Type)


10. REMOVE QUARTER TRIM PANEL ASSEMBLY REAR LH (Full Trim and Middle Roof Type)


    B113270
  1. Using a screwdriver, disengage the 21 clips and remove the quarter trim panel assembly rear LH.

    HINT:
    Tape the screwdriver tip before use.



11. REMOVE QUARTER TRIM PANEL ASSEMBLY REAR LH (Full Trim and High Roof Type)


    B113348
  1. Using a screwdriver, disengage the 35 clips and remove the quarter trim panel assembly rear LH.

    HINT:
    Tape the screwdriver tip before use.



12. REMOVE SIDE NO.1 TRIM ASSEMBLY LH (Full Trim Type)


    B113349
  1. Using a screwdriver, disengage the 21 clips and remove the side No.1 trim assembly LH.

    HINT:
    Tape the screwdriver tip before use.



13. REMOVE COOLER CONTROL SWITCH KNOB


    E103905
  1. Remove the cooler control switch knob.



14. REMOVE HEATER SWITCH ASSEMBLY


    E103906
  1. Remove the 2 screws and heater switch assembly.