STARTING SYSTEM > INSPECTION |
| 1. INSPECT STARTER ASSEMBLY |
![]() |
Perform the pull-in test.
Disconnect the field coil lead wire from terminal C.
![]() |
Connect the battery to the magnetic switch as shown in the illustration. Check that the clutch pinion gear is extended.
![]() |
Perform the hold test.
Disconnect the negative (-) lead from terminal C while sustaining the above condition (a). Check that the pinion gear remains extended.
![]() |
Check the return operation.
Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns inward.
![]() |
Perform the operation test without any load.
Connect the field coil lead wire to terminal C.
![]() |
Clamp the starter in a vise.
Connect the battery and ammeter to the starter as shown in the illustration.
Check that the ammeter indicates the specified current.