Home › ENGINE ยท 5L-E › STARTING › STARTER (for 2.7kW Type)

STARTER (for 2.7kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY


    A112469E01
  1. Remove the 2 bolts and nut, and disconnect the terminal C wire.

  1. Pull out the starter yoke assembly with the armature assembly.



2. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A112470
  1. Remove the 3 screws and magnet starter switch assembly.

  1. Remove the return spring.



    A112471E01
  1. Remove the following parts from the starter housing.
    (1)
    Starter clutch sub-assembly
    (2)
    Starter idler pinion
    (3)
    Retainer
    (4)
    Clutch roller
    (5)
    Plate washer



    A112472E01
  1. Using a magnetic finger, remove the steel ball.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    A112473
  1. Remove the 2 screws and commutator end frame assembly.



    A112474
  1. Using a screwdriver, hold the spring back and disconnect the brush.

  1. Disconnect the 4 brushes and remove the brush holder assembly.



4. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.