Home › ENGINE ยท 5L-E › STARTING › STARTER (for 2.7kW Type)

STARTER (for 2.7kW Type) > REASSEMBLY

for Preparation Click here



1. INSTALL STARTER ARMATURE ASSEMBLY


    A071182
  1. Install the starter armature to the starter yoke.



2. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Place the brush holder assembly on the starter yoke assembly.



    A112474
  1. Using a screwdriver, hold the brush spring back.

  1. Connect the brush into the brush holder.

  1. Connect the 4 brushes.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.



    A102628
  1. Install the commutator end frame with the 2 screws.

    Torque:
    3.6 N*m{ 37 kgf*cm , 32 in.*lbf }



3. INSTALL MAGNET STARTER SWITCH ASSEMBLY
  1. Apply grease to the steel ball, and return spring.

  1. Install the steel ball into the magnet starter switch hole.

  1. Insert the return spring into the magnet starter switch hole.



    A112471E04
  1. Place the following parts in position on the starter housing.
    (1)
    Starter clutch sub-assembly
    (2)
    Starter idler pinion
    (3)
    Retainer
    (4)
    Clutch roller
    (5)
    Plate washer



    A112470
  1. Install the starter housing to the magnet magnet switch assembly with the 3 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }



4. INSTALL STARTER YOKE ASSEMBLY
  1. Install the felt washer to the starter armature.



    A112486E01
  1. Install the starter yoke to the starter switch.

    HINT:
    Align the claw of the starter yoke with the groove of the starter switch.



    A112469
  1. Tighten the 2 through bolts.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 ft.*lbf }

  1. Connect the terminal C wire with the nut.

    Torque:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }