Home › BODY ELECTRICAL › HORN › HORN RELAY

HORN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FUSE (HAZ-HORN)
  1. Check the resistance of HAZ-HORN fuse.

    Standard Resistance:
    Below 1 Ω

    If the result is not as specified, replace the fuse.



2. INSPECT HORN RELAY


    B112418E01
  1. Disconnect the horn relay connector.

  1. Measure the resistance according to the value in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C1 - A7
    Always
    Below 1 Ω
    C1 - A6
    Always
    10 kΩ or higher
    C1 - A6
    When battery voltage is applied to terminals C1 and A7.
    Below 1 Ω

    If the result is not as specified, replace the relay.