Home › ENGINE · 2KD-FTV › CHARGING › GENERATOR

GENERATOR > INSPECTION

for Preparation Click here



1. INSPECT GENERATOR WITH CLUTCH PULLEY


    A115864E01
  1. When rotating the pulley, check that it turns clockwise and it does not turn counterclockwise.



2. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY


    A113754E01
  1. Using vernier calipers, measure the brush length.

    Standard length:
    10.5 mm (0.413 in.)

    Minimum length:
    4.5 mm (0.177 in.)

    If the length is less than the minimum, replace the brush holder assembly.



3. INSPECT GENERATOR ROTOR ASSEMBLY


    A079306
  1. Inspect that the bearing is not rough or worn.
    If necessary, replace the rotor.



    B012264E01
  1. Check the rotor for open circuit.

    1. Using an ohmmeter, measure the resistance between the slip rings.

      Standard resistance:
      2.3 to 2.7 Ω at 20°C (68°F)

      If the resistance is not within the standard range, replace the rotor.



    B012265E01
  1. Check the rotor for ground.

    1. Using an ohmmeter, check that there is no continuity between the slip ring and rotor.
      If there is continuity, replace the rotor.



    B012266
  1. Using vernier calipers, measure the slip ring diameter.

    Standard diameter:
    14.2 to 14.4 mm (0.559 to 0.567 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    If the diameter is less than the minimum, replace the rotor.