Home › ENGINE · 5L-E › STARTING › GLOW PLUG

GLOW PLUG > INSPECTION

for Preparation Click here



1. INSPECT GLOW PLUG RELAY


    A112493E01
  1. Resistance inspection.

    1. Using an ohmmeter, measure the resistance between each terminal.

      Specified condition:
      Between terminal
      Specified condition
      1-2
      10or higher
      3-4
      Below 1Ω

    2. Using an ohmmeter, measure the resistance between terminals 1 and 2 when the battery voltage is applied across terminals 3 and 4.

      Specified condition:
      Below 1Ω