Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › HEATER RADIATOR ASSEMBLY

HEATER RADIATOR ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT HEATER RADIATOR SUB-ASSEMBLY


    E109936E01
  1. Remove the heater radiator sub-assembly and disconnect the connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    e1-1 - e2-1
    Always
    Below 1 Ω
    e1-2 - e2-1
    Always
    Below 1 Ω
    e1-3 - e2-2
    Always
    Below 1 Ω

    If the resistance value is not specified, replace the rear blower resistor.