Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR BLOWER SWITCH

REAR BLOWER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT REAR BLOWER SWITCH


E103730E01
  1. Remove the rear blower switch and disconnect the connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Switch condition
    Specified condition
    2 (B) - 3 (E) - 6 (D)
    OFF
    10 kΩ or higher
    2 (B) - 3 (E) - 6 (D)
    ON
    Below 1 Ω
    1 (ILL+) - 4 (ILL-)
    Always
    Below 1 Ω

    If the resistance value is not as specified, replace the rear blower switch.

  1. Connect the positive battery to terminal 1 (ILL+), and the negative battery terminal to terminal 4 (ILL-).

    OK:
    The illumination light of the rear blower switch come on.

    If the resistance value is not as specified, replace the rear blower switch.