Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › PTC HEATER RELAY

PTC HEATER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT PTC HEATER RELAY


    E063287E01
  1. Remove the PTC heater relay from engine room R/B No.1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    3 - 5
    Always
    10 kΩ or higher
    3 - 5
    Battery voltage to terminals 1 and 2
    Below 1 Ω

    If the resistance value is not as specified, replace the PTC heater relay.