Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR BLOWER SWITCH (for Heater)

REAR BLOWER SWITCH (for Heater) > INSPECTION

for Preparation Click here



1. INSPECT HEATER CONTROL SWITCH
  1. Remove the heater control switch and disconnect the connector.



    E103713
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Switch position
    Specified condition
    Each terminal
    OFF
    10 kΩ or higher
    4 - 8
    LO
    Below 1 Ω
    1 - 4 - 8
    LO - ME
    Below 1 Ω
    1 - 4 - 8
    ME
    Below 1 Ω
    1 - 4 - 6 - 8
    ME - HI
    Below 1 Ω
    4 - 6 - 8
    HI
    Below 1 Ω

    If the resistance value is not as specified, replace the heater control switch.