Home › ENGINE ยท 5L-E › LUBRICATION › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL OIL PUMP DRIVE GEAR


    A057459E01
  1. Place the timing gear case on wooden blocks.

    NOTICE:
    Do not damage the timing pointer.

  1. Insert the drive and driven gears into the timing gear case with the marks facing the oil pump cover side.



    A057460E01
  1. Apply adhesive to 2 or 3 threads of the screws.

    Adhesive:
    Part No.08833-00080, THREE BOND 1344 LOCTITE 242 or equivalent

  1. Install the oil pump cover with the 8 screws.

    Torque:
    10 N*m{ 105 kgf*cm , 7 ft.*lbf }



2. INSTALL OIL PUMP RELIEF VALVE
  1. Insert the relief valve and spring into the installation hole of the timing gear case.



    A057453E02
  1. Using a 12 mm hexagon wrench, install a new gasket and the plug.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



3. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    A057640E02
  1. Using SST and a hammer, tap in a new oil seal to the depth of 0.5 mm (0.020 in.) from the oil pump case edge.

    SST
    09214-60010  

  1. Apply MP grease to the oil seal lip.