2KD-FTV CLUTCH UNIT > INSPECTION |
| 1. INSPECT CLUTCH DISC ASSEMBLY |
![]() |
Using vernier calipers, measure the rivet head depth.
![]() |
Install the clutch disc assembly to the transmission unit.
Using a dial indicator, check the clutch disc assembly runout.
| 2. INSPECT CLUTCH COVER ASSEMBLY |
![]() |
Using vernier calipers, inspect the diaphragm spring for the depth and width of wear.
| A (Depth): | B (Width): |
| 0.5 mm (0.020 in.) | 6.0 mm (0.236 in.) |
| 3. INSPECT FLYWHEEL SUB-ASSEMBLY |
![]() |
Using a dial indicator, inspect the flywheel sub-assembly runout.
| 4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY |
![]() |
Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.
Inspect the clutch release bearing assembly for damage or wear.