Home › ENGINE ยท 2KD-FTV › STARTING › PRE-HEATING SYSTEM

PRE-HEATING SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here


NOTICE:
Turn the ignition switch off for 60 seconds before performing the following inspections:



1. INSPECT LIGHTING TIME OF GLOW INDICATOR LIGHT


    A114042E01
  1. Turn the ignition switch to the ON position, and measure the lighting time.

    Lighting time:
    Refer to the graph.



2. INSPECT PRE-HEATING


    A114043E01
  1. Turn the ignition switch to the ON position, measure the time when the battery voltage is applied to the glow plugs.

    Pre-Heating time:
    Engine coolant temperature
    Pre-Heating time
    40°C or more
    1 sec.
    Less than 40°C
    Refer to the graph (15 sec. at the longest)

  1. Turn the ignition switch to the START position, and check that the battery voltage is applied to the glow plugs.

  1. While cranking the engine, measure the time when the battery voltage is applied to the glow plugs.

    Pre-Heating time:
    Engine coolant temperature
    Pre-Heating time
    40°C or more
    1 sec.
    Less than 40°C
    Refer to the chart graph (15 sec. at the longest)



3. INSPECT AFTER GLOW TIME


    A114044E01
  1. After starting the engine, measure the time when battery voltage is applied to terminal GREL of the ECM.

    After glow time:
    Refer to the graph.