Home › BODY ELECTRICAL › LIGHTING › PERSONAL LIGHT ASSEMBLY

PERSONAL LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT PERSONAL LIGHT ASSEMBLY


    B113719
  1. Remove the personal light assembly.

  1. Apply battery voltage to the personal light assembly connector.

  1. Check that the personal light comes on.

    OK:

    Measurement condition
    Switch condition
    Specified condition
    Battery positive (+) → Terminal 3
    Battery negative (-) → Terminal 1
    ON
    Personal light comes on
    Battery positive (+) → Terminal 3
    Battery negative (-) → Terminal 2
    DOOR
    Personal light comes on

    If the result is not as specified, replace the personal light assembly.