Home › BODY ELECTRICAL › LIGHTING › FRONT ROOM LIGHT ASSEMBLY

FRONT ROOM LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT ROOM LIGHT ASSEMBLY


    B113720
  1. Remove the front room light assembly.

  1. Apply battery voltage to the front room light assembly connector.

  1. Check that the front room light comes on.

    OK:

    Measurement condition
    Switch condition
    Specified condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Body ground
    ON
    Front room light comes on
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    DOOR
    Front room light comes on

    If the result is not as specified, replace the front room light assembly.

    HINT:
    Check that the ground wire of the front room light assembly is connected to body ground.