Home › BODY ELECTRICAL › LIGHTING › AUTOMATIC LIGHT CONTROL SENSOR

AUTOMATIC LIGHT CONTROL SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR


    B113713
  1. Measure the resistance and voltage according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified condition
    3 - Body ground
    Always
    Below 1 Ω

    Voltage:
    Tester connection
    Condition
    Specified condition
    1 - 3
    Always
    10 to 14 V
    4 - 3
    Ignition switch ON, Headlight dimmer switch in AUTO
    Pulse generation
    (See waveform 1)

    If the result is not as specified, the automatic light control sensor may have a malfunction.



      B113714E01
    1. Waveform 1
      Item
      Description
      Terminal
      CLTS (4) - CLTE (3)
      Gauge
      5 V/DIV, 5 ms/DIV
      Condition
      Ignition switch ON, Headlight dimmer switch in AUTO

      HINT:
      If the ambient light becomes brighter, width A becomes narrower.