Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSPECTION

for Preparation Click here



1. INSPECT IGNITION KEY CYLINDER LIGHT


    B113722
  1. Remove the ignition key cylinder light.

  1. Apply battery voltage to the ignition key cylinder light connector.

  1. Check that the ignition key cylinder light comes on.

    OK:
    Measurement condition
    Specified condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Ignition key cylinder light comes on

    If the result is not as specified, replace the ignition key cylinder light.