Home › BODY ELECTRICAL › LIGHTING › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HAZARD WARNING SWITCH


    B113723
  1. Inspect the hazard warning switch operation.

    1. Remove the hazard warning switch.

    2. Measure the resistance according to the value(s) in the table below.

      Resistance:
      Tester connection
      Switch operation
      Specified condition
      3 - 4
      OFF
      10 kΩ or higher
      3 - 4
      ON
      Below 1 Ω

      If the result is not as specified, replace the hazard warning switch.

  1. Inspect the illumination operation.

    1. Apply battery voltage to the hazard warning switch connector.

      OK:
      Measurement condition
      Specified condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Illumination comes on

      If the result is not as specified, replace the hazard warning switch.