Home › BODY ELECTRICAL › LIGHTING › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH


    B113724E01
  1. Remove the stop light switch.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Switch operation
    Specified condition
    1 - 2
    Switch pin free
    Below 1 Ω
    3 - 4
    Switch pin free
    10 kΩ or higher
    1 - 2
    Switch pin pushed in
    10 kΩ or higher
    3 - 4
    Switch pin pushed in
    Below 1 Ω

    If the result is not as specified, replace the stop light switch.