Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > PRECAUTION

for Preparation Click here



1.GENERAL PRECAUTION
  1. While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.


2.PRECAUTION FOR DISCONNECTING THE BATTERY CABLE

NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.


System Name
See procedure
Power Window Control System
Click here

3.PRECAUTION FOR WASHER NOZZLE (4WAY TYPE) HANDLING
  1. Do not adjust the washer nozzle with a safety pin, etc. as the washer nozzle tip is made of resin and could be damaged. Be sure to use SST for adjustment.

    SST
    95060-10010  

  2. When the washer nozzle is clogged with wax, etc., do not use metal objects such as a safety pin to clean the washer nozzle hole. Be sure to use a soft resin brush, etc.

  3. While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.