Home › ENGINE · 5L-E › COOLING › COOLING FAN SYSTEM

COOLING FAN SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT COOLING FAN RELAY


    A035654E01
  1. Measure the resistance

    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Terminals
      Specified condition
      Terminal 1 - Terminal 2
      175 Ω
      Terminal 3 - Terminal 5
      10 kΩ or higher

    2. Using an ohmmeter, measure the resistance between terminals 3 and 5 when battery voltage is applied between terminals 1 and 2 of the relay.

      Standard resistance:
      Below 1Ω



2. INSPECT COOLING FAN MOTOR
  1. Check that the motor turns smoothly when the battery is connected to the fan motor connector.

  1. Using an ammeter, measure the current while the motor is turning.

    Standard:
    17 to 23 A (20°C, 68°F, 12V)