COOLING FAN SYSTEM > INSPECTION |
| 1. INSPECT COOLING FAN RELAY |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between the terminals.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω (when battery voltage is applied between terminals 1 and 2) |
| 2. INSPECT COOLING FAN MOTOR |
Check that the motor turns smoothly when the battery is connected to the fan motor connector.
Using an ammeter, measure the current while the motor is turning.
| 3. ENGINE COOLANT TEMPERATURE SENSOR |
Partially soak the sensor in the water and warm up the water.

Measure the resistance between the terminals.
| Condition | Specified Condition |
| Approx. 20°C (68°F) | 2.32 to 2.59 kΩ |
| Approx. 80°C (176°F) | 0.310 to 0.326 kΩ |