Home › ENGINE · 2KD-FTV › COOLING › COOLING FAN SYSTEM

COOLING FAN SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT COOLING FAN RELAY


    A035654E01
  1. Check the resistance

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      3 - 5
      Below 1 Ω (when battery voltage is applied between terminals 1 and 2)

      If the result is not as specified, replace the relay.



2. INSPECT COOLING FAN MOTOR
  1. Check that the motor turns smoothly when the battery is connected to the fan motor connector.

  1. Using an ammeter, measure the current while the motor is turning.

    Standard:
    17 to 23 A (20°C, at 12)



3. ENGINE COOLANT TEMPERATURE SENSOR


  1. Partially soak the sensor in the water and warm up the water.


    A108624E01

  1. Measure the resistance between the terminals.

    Standard resistance:

    Condition
    Specified Condition
    Approx. 20°C (68°F)
    2.32 to 2.59 kΩ
    Approx. 80°C (176°F)
    0.310 to 0.326 kΩ

    If the result is not as specified, replace the sensor.

    NOTICE:
    When checking the sensor in the water, keep the terminals dry. After the check, wipe the sensor dry.