COOLING FAN SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT COOLING FAN SYSTEM |
Put the vehicle in the following state:
The ignition switch is off.
The coolant temperature is less than 76°C (169°F).
The battery voltage is between 11 and 14 V.
The A/C switch is off.
Connect the 400 A probe of the ammeter to the M+ terminal of the cooling fan motor.
Turn the ignition switch to the ON position (engine off) and wait for approximately 10 seconds. Check that the fan stops.
Start the engine. Check that the fan stops with the engine idling.
Check that the fan operates when the A/C switch is turned on (The temperature is set to MAX COOL and the magnet clutch is operating).
Check that the fan operates when the coolant sensor connector is disconnected.
![]() |
After the engine has warmed up, the fan operates as shown in the illustration.
| 2. INSPECT COOLING FAN ECU |
![]() |
Check the input voltage.
Disconnect the cooling fan ECU connector.
Turn the ignition switch to the ON position. Measure the voltage of the +B terminal of the disconnected harness side connector.
If the terminal voltage is not within the specification, inspect the power source system (fusible link, fuse, wire harness, relay).
Inspect the cooling fan motor.
Inspect the wire harness.
Disconnect the ECM and cooling fan ECU connectors.
Check continuity and the insulator condition between the terminals of the ECM (RFC) and cooling fan ECU (SI).
Inspect the ECM power source circuit and ground circuit.
![]() |
Inspect the input signal and output current.
Connect the 400 A probe of the ammeter to the M+ terminal of the cooling fan motor.
Set the Intelligent Tester to the oscilloscope function.
Using the Intelligent Tester, check waveform between terminals RFC and E1 of the ECM.
| Condition | Input signal | Output current |
| Engine stopped IG switch ON | Waveform 1 (Duty ratio 0 %) | (Fan stops) |
| Engine idling A/C OFF | Waveform 1 (0 %) | (Fan stops) |
| Engine idling A/C ON | Waveform 2 (30 to 75 %) | 4 to 23 A (Fan operates) |
| Engine idling and ECT sensor connector disconnected | Waveform 3 (60 to 75 %) | 8 to 24 A (Fan operates) |