Home › TRANSMISSION ยท R351 MANUAL TRANSMISSION › SHIFT LEVER SHAFT HOUSING

SHIFT LEVER SHAFT HOUSING > DISASSEMBLY

for Preparation Click here



1. REMOVE SELECT OUTER LEVER LOCK PIN


    C114252
  1. Loosen the nut of the select outer lever lock pin until the top of the nut becomes flush with the end of the lock pin.



    C114245
  1. Using a brass bar and a hammer, disengage the select outer lever lock pin.

  1. Remove the nut, washer and select outer lever lock pin from the shift lever shaft housing assembly.



2. REMOVE SELECT OUTER LEVER


    C114246
  1. Remove the select outer lever and washer from the select lever shaft sub-assembly.



3. REMOVE SELECT LEVER SHAFT SUB-ASSEMBLY


    D026097
  1. Remove the select lever shaft sub-assembly from the shift lever shaft housing.



4. REMOVE LEVER LOCK PIN NO.2


    C114251
  1. Loosen the nut of the lever lock pin No.2 until the top of the nut becomes flush with the end of the lock pin.



    C114247
  1. Using a brass bar and a hammer, disengage the lever lock pin No.2.

  1. Remove the nut, washer and lever lock pin No.2 from the shift lever shaft housing assembly.



5. REMOVE SHIFT OUTER LEVER NO.1


    C114248
  1. Remove the shift outer lever No.1 from the shift and select lever shaft.



6. REMOVE SHIFT LEVER BOOT


    D026100
  1. Remove the shift lever boot from the shift lever shaft housing.



7. REMOVE SHIFT AND SELECT LEVER SHAFT


    C114274
  1. Using a pin punch (5 mm) and a hammer, remove the shift lever shaft set slotted pin.

    NOTICE:
    Be careful not to damage the shift and select lever.



    C114275E01
  1. Pull out the shift and select lever shaft from the shift lever shaft housing.



8. REMOVE SHIFT AND SELECT LEVER


    C114253
  1. Remove the shift and select lever, select spring seat No.1 and spring from the shift lever shaft housing.



9. REMOVE REVERSE RESTRICT PIN SLOTTED SPRING PIN


    D026104
  1. Using a hammer, drive a screw extractor into the reverse restrict pin slotted spring pin.

  1. Pull out the reverse restrict pin slotted spring pin from the shift lever shaft housing.



10. REMOVE REVERSE RESTRICT PIN NO.1


    D026105
  1. Remove the reverse restrict pin No.1 and compression spring from the shift lever shaft housing.

  1. Remove the compression spring from the reverse restrict pin No.1.



11. REMOVE SHIFT LEVER NO.2 SHAFT OIL SEAL


    C114272
  1. Using a screwdriver with its tip taped, remove the shift lever No.2 shaft oil seal from the shift lever shaft housing.

    NOTICE:
    Be careful not to damage the shift lever shaft housing.



12. REMOVE SHIFT LEVER SHAFT OIL SEAL


    C114273
  1. Using a screwdriver with its tip taped, remove the shift lever shaft oil seal from the shift lever shaft housing.

    NOTICE:
    Be careful not to damage the shift lever shaft housing.