Home › TRANSMISSION ยท R351 MANUAL TRANSMISSION › SHIFT LEVER SHAFT HOUSING

SHIFT LEVER SHAFT HOUSING > REASSEMBLY

for Preparation Click here



1. INSTALL SHIFT LEVER SHAFT OIL SEAL


    C114276E01
  1. Using SST, install a new oil seal until its surface is flush with the housing end surface.

    SST
    09950-60010   (09951-00290)
    09950-70010   (09951-07100)

  1. Apply MP grease to the oil seal lip.



2. INSTALL SHIFT LEVER NO.2 SHAFT OIL SEAL


    C114277E01
  1. Using SST, install a new oil seal until its surface is flush with the housing end surface.

    SST
    09950-60010   (09951-00190)
    09950-70010   (09951-07100)

  1. Apply MP grease to the oil seal lip.



3. INSTALL REVERSE RESTRICT PIN NO.1


    D026105
  1. Coat the reverse restrict pin No.1 with gear oil.

  1. Install the spring to the reverse restrict pin No.1.

  1. Install the reverse restrict pin No.1 and spring to the shift lever shaft housing.



4. INSTALL REVERSE RESTRICT PIN SLOTTED SPRING PIN


    D026110
  1. Using a pin punch (5 mm) and a hammer, install the slotted spring pin to the shift lever shaft housing.



5. INSTALL SHIFT AND SELECT LEVER


    C114253
  1. Coat the select spring seat No.1 with gear oil.

  1. Install the shift and select lever, select spring seat No.1 and spring to the shift lever shaft housing.



6. INSTALL SHIFT AND SELECT LEVER SHAFT


    C114275E02
  1. Coat the shift and select lever shaft with gear oil.

  1. Install the shift and select lever shaft to the shift lever shaft housing.



    C114274
  1. Using a pin punch (5 mm) and a hammer, install the shift lever shaft set slotted pin to the shift and select lever shaft.



7. INSTALL SHIFT LEVER BOOT


    D026100
  1. Install the shift lever boot to the shift lever shaft housing.



8. INSTALL SHIFT OUTER LEVER NO.1


    C114248
  1. Install the shift outer lever No.1 to the shift and select lever shaft.



9. INSTALL LEVER LOCK PIN NO.2


    C114251
  1. Install the lever lock pin No.2 and nut to the shift outer lever No.1.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



10. INSTALL SELECT LEVER SHAFT SUB-ASSEMBLY


    D026097
  1. Coat the select lever shaft sub-assembly with gear oil, and install it to the shift lever shaft housing.



11. INSTALL SELECT OUTER LEVER


    C114246
  1. Install the select outer lever and washer to the select lever shaft sub-assembly.



12. INSTALL SELECT OUTER LEVER LOCK PIN


    C114252
  1. Install the select outer lever lock pin and nut to the select outer lever.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }