Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › SUN GEAR AND ONE-WAY CLUTCH

SUN GEAR AND ONE-WAY CLUTCH > DISASSEMBLY

for Preparation Click here



1. INSPECT 1 WAY CLUTCH ASSEMBLY


    AT08440E02
  1. Hold the planetary sun gear, and turn the 2nd brake hub. Check that the 2nd brake hub can be turned freely clockwise and locked counterclockwise.



2. REMOVE 1 WAY CLUTCH ASSEMBLY


    AT08188
  1. Remove the 1 way clutch assembly.



3. REMOVE 1 WAY CLUTCH THRUST WASHER NO.1


    AT01642
  1. Remove the 1 way clutch thrust washer No.1.



4. REMOVE SUN GEAR SHAFT OIL SEAL RING


    AT08189
  1. Remove the sun gear shaft oil seal rings.



5. REMOVE SUN GEAR INPUT DRUM


    AT08190
  1. Use a wooden block or similar object as a work stand.



    AT07897
  1. Using a snap ring expander, remove the snap ring.

  1. Remove the sun gear input drum from the planetary sun gear.



6. REMOVE SUN GEAR INPUT DRUM SHAFT SNAP RING


    AT08182
  1. Using a screwdriver, remove the snap ring from the planetary sun gear.



7. INSPECT PLANETARY SUN GEAR SUB-ASSEMBLY


    AT08337
  1. Using a dial indicator, measure the inside diameter of the planetary sun gear bushings.

    Maximum inside diameter:
    27.08 mm (1.0661 in.)

    If the inside diameter is greater than the maximum, replace the planetary sun gear.